9 answers: flashing where siding meets concrete ?

Flashing is a thin, waterproof material that is installed at the intersection of two different materials to prevent water from seeping in. When siding meets concrete, flashing is necessary to prevent water from penetrating the joint and causing damage to the structure.

To install flashing where siding meets concrete, follow these steps:

1. Clean the area where the siding meets the concrete. Remove any dirt, debris, or old caulking.

2. Cut a piece of flashing to the length of the joint. The flashing should be wide enough to cover the joint and extend up the siding and down the concrete by at least 2 inches.

3. Apply a bead of silicone caulk along the top edge of the flashing.

4. Press the flashing into place, making sure it is centered over the joint.

5. Use a hammer and roofing nails to secure the flashing to the siding. The nails should be placed about 6 inches apart.

6. Apply another bead of silicone caulk along the bottom edge of the flashing.

7. Press the flashing down onto the concrete, making sure it is flush with the surface.

8. Use masonry screws and anchors to secure the flashing to the concrete. The screws should be placed about 6 inches apart.

9. Apply another bead of silicone caulk along the bottom edge of the flashing to seal the joint.

10. Allow the caulk to dry completely before painting or finishing the siding.

By accessing the information about flashing where siding meets concrete on reputable and authoritative information websites, you can gain a deeper understanding and gather more details on the topic.